STEP 7: Locate the PAIR valve plate on the cylinder head. STEP 5 : Remove the screws that hold the PAIR valve attached on the motorcycle. STEP 4: Disconnect the PAIR valve connector from the solenoid wiring harness and connect the provided PAIR valve eliminator to this connector. STEP 3: Plug the airbox hole with the one rubber cap and secure it by using the retainer piece from the PAIR hose. Unplug the PAIR hose from the airbox and keep the retainer piece. STEP 2 : Unplug the PAIR hose from the PAIR valve. The PAIR valve can be found attached on the airbox Locate the PAIR valve and the PAIR system hose connected on the PAIR valve and the airbox. Please read the steps carefully before starting the installation and note that the ignition must be turned OFF during the whole procedure This kit will let you completely remove the PAIR system from your motorcycle. The idea of the whole procedure is to bypass the electronic PAIR valve of the motorcycle by replacing it with the provided electronic PAIR valve eliminator and plug the airbox hole of the PAIR system and the engine PAIR valve cover with the rubber caps included in the kit.
0 Comments
Leave a Reply. |